Roller bed with 2-1/2″ diameter x 11 gauge unplated rollers spaced every 4 or 6″. Tread rollers mounted in 4″ x 4 gauge formed channel on side opposite chain guard and 6″ x 4 gauge formed channel on chain guard side. Bolted together with butt couplings.
No. 40 roller-to-roller.
Formed steel guards totally enclose drive chains.
Sealed, pre-lubricated ball bearings.
Shaft mounted gearmotor located near center of each zone. 1/2 HP – 3 PH 60 Hz. Totally enclosed fan cooled. 230/460 V (specify voltage). Includes EZDriveTM Disconnect Panel. Power is distributed zone to zone through pluggable cordsets. Power is connected from the starter box to the motor via “SO” type cord. Please contact factory if local code requires other than the standard power distribution techniques described.
4″ roller centers, 32″ to 120″ on 4″ increments. 3 in. and 6″ roller centers, 30″ to 120″ on 6″ increments. 5″ roller centers, 30″ to 120″ on 5″ increments. Frame length changes with zone length.
Located in each zone (Retro-Reflective). NEMA 1, 2, IP 62. UL Approved.
Provides 27VDC, 100 watt power for EZLogic® accumulation system – contains slots for 4 input/output boards. Should be located near disconnect panel. See chart for maximum quantity of zones. Requires 120VAC or 230VAC single phase input.
28 FPM constant
Maximum load per linear foot of conveyor 300 lbs with supports on 10 ft. centers and 1000 lbs with supports on 5 ft. centers. Maximum unit load 4000 lbs per zone with 4” roller centers and #40 chain. Zones longer than 6 ft. may require an additional floor support depending on product load.
Supplied as optional equipment.
25-CREZD Zero Pressure Accumulating Conveyor
Enter your name and email address to subscribe to our newsletter featuring the latest in material handling and storage solutions (opt out at anytime).
